NC Drill
edward , 07-11-2019, 10:44 AM
Hi Robert,
I am generating the Fab output the Gerber file came out properly, I followed ail your instructions but the NC drill did not come out correctly. It is just a blob. I attached the file in my email the other can you please take a look and see what is going on.
Thanks
I am generating the Fab output the Gerber file came out properly, I followed ail your instructions but the NC drill did not come out correctly. It is just a blob. I attached the file in my email the other can you please take a look and see what is going on.
Thanks
robertferanec , 07-11-2019, 11:30 AM
Hi Edward, and what is wrong with the file?
edward , 07-11-2019, 11:50 AM
When I import the NC drill into Viewmate. Please see below
robertferanec , 07-11-2019, 12:49 PM
Try to generate it in mm or mil. I think this may happen if you generate the file in mm / mils (I think, the file is still ok, just ViewMate can't recognize the units?)
PS: When you open the file in text editor, you can see the content should be correct.
PS: When you open the file in text editor, you can see the content should be correct.
edward , 07-12-2019, 10:38 AM
It work only in mil but not in mm.
robertferanec , 07-12-2019, 12:57 PM
Thank you @edward for confirmation
Use our interactive Discord forum to reply or ask new questions.