USE DISCOUNT CODE
EXPERT30
TO SAVE $30 USD
How to create a board outline clearance
Nikosant03 , 01-24-2022, 09:33 AM
Hi everyone!!
I want to create a board outline clearance. What is the recommended way of doing that?
Define a rule under Manufacturing -> Board Outline Clerance or though the clerance rule under Electrical -> Clerance?
Is there another way to do that? Also is it required to have keep-out layer?
Thanks
I want to create a board outline clearance. What is the recommended way of doing that?
Define a rule under Manufacturing -> Board Outline Clerance or though the clerance rule under Electrical -> Clerance?
Is there another way to do that? Also is it required to have keep-out layer?
Thanks
qdrives , 01-24-2022, 02:25 PM
The board outline clearance is often bigger than the 'normal' clearance. Recomended >= 0.3mm. So, use the board outline clearance section.
The use of keep-out may be required if additional clearance is needed for special reasons, like mouse bites or V-scoring.
The use of keep-out may be required if additional clearance is needed for special reasons, like mouse bites or V-scoring.
Use our interactive Discord forum to reply or ask new questions.