| FORUM

FEDEVEL
Platform forum

routing on power or gnd layer in 6layer pcb

kamikazi , 03-17-2018, 04:33 AM
hi
i want to design one 6layer pcb for AM3358 TI processor about stack up layer i set in this case :
layer 1 :signal
layer 2 : gnd
layer 3 : power
layer4 : signal
layer 5 : gnd
layer 6 : signal
size of this board is very small (40x40mm) and routing in 3 layer is very hard i want to know in layer5(gnd) i can set one plane under high speed signal (such as under ddr3) and i rout other track that no need controlling impedance on empty space (such as gpio) on layer 5 pls guide me thanks
robertferanec , 03-17-2018, 09:11 AM
I always try to have some solid GND planes in PCB. I would not cut it down - the ground loops are travelling under the whole circuits, I am not really sure how helpful it would be to leave solid ground under memory layout and remove it in other places.

I would try to find a way how to do it with solid GND planes.
Use our interactive Discord forum to reply or ask new questions.
Discord invite
Discord forum link (after invitation)

Didn't find what you were looking for?