heatsink holes
amorim317 , 08-06-2018, 12:27 PM
hi, anyone knows what kind of heat sink should i use on those holes in the board?... the holes are not symmetrical with the processor location and I can´t find a heatsink(with cooler is a plus) with those dimensions.
thinking about using this https://www.digikey.com/product-deta...400-ND/1216404 at my project... but it is not a commercial solution, as I would have to improvise an asymmetrical strap.
thinking about using this https://www.digikey.com/product-deta...400-ND/1216404 at my project... but it is not a commercial solution, as I would have to improvise an asymmetrical strap.
amorim317 , 08-07-2018, 08:45 AM
sorry, the picture was not fully attached at the previous post.
robertferanec , 08-08-2018, 08:06 AM
Are you asking about iMX6Rex or OpenRex?
I am not sure how VOIPAC it is managing the heatsinks, maybe ask them, they may sell you the heatsink directly.
For OpenRex, I think we used this one from Farnell (Code: 4620938):
http://sk.farnell.com/fischer-elektr...vakia%2Fsearch
For iMX6Rex, I think we tried this one from farnell (Code: 1211719 ) + we drilled the holes:
http://sk.farnell.com/fischer-elektr...vakia%2Fsearch
I am not sure how VOIPAC it is managing the heatsinks, maybe ask them, they may sell you the heatsink directly.
For OpenRex, I think we used this one from Farnell (Code: 4620938):
http://sk.farnell.com/fischer-elektr...vakia%2Fsearch
For iMX6Rex, I think we tried this one from farnell (Code: 1211719 ) + we drilled the holes:
http://sk.farnell.com/fischer-elektr...vakia%2Fsearch
Use our interactive Discord forum to reply or ask new questions.